Pepper-computer Modular Computers RS485 Bedienungsanleitung PDF herunterladen (Seite 212)

SMART I/O User’s Manual

March 12, 1996

Page 5 - 56

Chapter 5 Analog Modules

5.2.9 ISaGRAF Programming

5.2.9.1 The ISaGRAF Board Parameters

Information on board parameters may be found in the PEP online help and

ISaGRAF online help or user’s manual.

Figure 5.2.9.1.1 a Typical Screen Section for the SM-PT100 Module

Logical Address

The 4 inputs of this module may be clearly seen together with the logical

address at which this particular board is residing. Remember, this logical

address is the same as the physical slot position! In the example shown here,

the board being addressed is in slot 3 i.e. the third of the SMART-BASE

slots. Up to 11 slots are catered for in the SMART I/O concept; 3 on the

SMART-BASE and 2 for each connected SMART-EXT (up to a total of 4).

Module Specific Information :

calib_period : This is the time in seconds for cyclic calibration if

required. An entry of zero disables the function.

type_ch(x) : This parameter is either resistor100 or PT100

depending whether the returned value should be raw

ohmic or calibrated in degrees Celsius respectively.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 319 320

Keine Kommentare

Pepper-computer Modular Computers RS485 Bedienungsanleitung Seite 212