Pepper-computer Modular Computers RS485 Bedienungsanleitung PDF herunterladen (Seite 307)

SMART I/O User’s Manual

Chapter 6 Communications Modules

6.2.7.9 STAT2 Register

PE parity error on last transmission (True/False)

TC transmission complete (True/False)

ER1 current status of end-of-range switch 1

ER2 current status of end-of-range switch 2

MH comparison match (True/False)

6.2.7.10 Data Register

The data register, cleared after a power-on reset is a 24-bit register containing

the result of the last encoder reading. When using encoders with less than 24-

bit data, the result is always aligned from the lowest significant bit and the

used upper bits are always cleared.

Note

Interrupt pending flags (IP0 - IP4) are set by the interrupt source if the

corresponding line is not masked in the CTRL1 register. All flags are

cleared when the STAT1 register is read.

Note

The MH flag is set internally as soon as the encoder reaches the preset

This feature is intended for use with the board in automatic mode to allow

slow polling of the status registers while ensuring that a match is not lost.

ST2-7 ST2-6 ST2-5 ST2-4 ST2-3 ST2-2 ST2-1

unused unused unused MH ER2 ER1 TC

1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 319 320

Keine Kommentare

Pepper-computer Modular Computers RS485 Bedienungsanleitung Seite 307