Pepper-computer Modular Computers RS485 Bedienungsanleitung PDF herunterladen (Seite 36)

100

101

SMART I/O User’s Manual

March 12, 1996

Page 1 - 24

Introduction

In order to verify that the hardware and software have been correctly setup,

the following procedure should be followed.

• Connect the D-Sub connector end of the terminal cable to the chosen

COM port of the computer. The other end, with the telephone type

connector should be pushed into place in the RS232-port of the

SMART I/O base (see figure 1.4.3.1)

• With the power supply turned OFF, connect the power plug to SCR-2

on the SMART base.

• Start the ISA-Terminal program.

• Switch on the power supply to the SMART I/O; three green LEDs

should illuminate on the control panel (not the SMART Modules!). The

terminal should display the messages shown in figure 1.5.3.2.

Figure 1.5.3.2 Power Up Messages

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 319 320

Kommentare zu diesen Handbüchern

Keine Kommentare

Pepper-computer Modular Computers RS485 Bedienungsanleitung Seite 36

Kommentare zu diesen Handbüchern